|
PIE 532 4-20 mA Loop Calibrator
4-20
mA/V Loop Calibrator with Auto Ramping and Loop
Diagnostics
PRICE STARTING
AT $995.00
The Practical Instrument
Electronics’ Model 532 is the best tool for calibration, test, and
diagnosing process loops. The Model 532 brings all the features you
would expect from a loop calibrator and timesaving new ones. Make
adjustments with the EZ-Dial Knob or test limits with the dual
action EZ-Check Switch. Powerful ramping functions are only a button
away on the Model 532. Save potentially hours of troubleshooting
time on problem loops with the 532’s unique Loop Diagnostic Mode. In
Loop Diagnostic Mode, the loop current, voltage, resistances, AC
voltage, and mode of operation are all displayed simultaneously;
without the need of multiple DMM connections. Loop diagnostic is
available in every mode of operation and truly is a diagnostic
monitor, as parameters are continuously updated in real time. The
smart diagnostic tool even indicates the most likely cause of loop
failure!
|
Manufacturer PIE
Quick
Specs
4 to 20 mA Loop Functions
Source and Read 0.000-24.000 mA
Simulate 2-Wire Transmitters
Power 2-Wire Transmitters and Read 0.000-24.000 mA
Display current in mA or -25.00-125.00 % of 4-20 mA
Read 0.00 to ± 30.00 VDC with 4X over range ability
Source 0.000 to 24.000 VDC with up to 20 mA output
Direct Calibration 1.000V to 5.000V
Full 5 Digit Display
True ±0.012% of reading accuracy
Bar graph for quick reference of input and output levels
High contrast graphic display viewable in all lighting
conditions and angles
Loop Diagnostic
Displays loop current, voltage, resistance, AC voltage and mode
of operation simultaneously eliminating multiple DMM connections
Make DYNAMIC loop readings under actual operating conditions
Included in the loop diagnostic features is its ability to
measure ground current leakage from faulty wiring, flooded conduit,
and corrosion bridges. This leakage subtracts from the signal
current sensed by the receiving system (ie: DCS), causing a
measurement error
Change the speed of dialing your test point by just pushing down
on the EZ-Dial Knob
Easily adjust output by 0.001 mA (0.01%) or 0.100 mA (1.00%)
EZ-Check Switch with EZ-Step Button
3 position tactile switch with push button for true one handed
calibrations
Push button for stepping through calibration points
16 different step sizes
Hands-free auto step and auto ramp modes
Selectable soak and step time for working with valves
Uses a standard 9V Alkaline Battery
Superior battery life of 40 hours under typical continuous usage
Easy access to battery compartment
240 VAC Tolerant
Fuse-less protection from accidental misuse
Lightweight and rugged with a solid feel
Convenient Velcro® hand strap allows for a firm confident grip
or attachment to pipes and ladders
HART® protocol compatibility mode
Power on selectable 250@ resistor in series with the output for
compatibility with HART® protocol enabled devices
|
PATHFINDER
INSTRUMENTS
Order or Shop On Line